The parameter panel holds all configurable options for the reaction
run. The basic parameters for the reaction will be set using the Reaction
Wizard but all parameters can be edited in the panel later on to optimize
the reaction. The panel can be detached from the Reaction Window to make
more room for the data displays. The detached parameter panel looks like
this:
The panel contains different tabs which provide
settings for the view, the reaction phases, the instrument and saving
parameters, the reaction limits and the preprocessing. Apart from the
limits and preprocessing, all other tabs basically duplicate the configuration
settings from the Reaction Wizard.
The view parameters show all settings relevant to the overall visual
configuration of the Reaction Window. These settings will initially be
defined in Step 5 of the Reaction Wizard. Please refer
to that chapter for a detailed description of the parameters. To customize
the reaction window by rearranging the separate view window position check
the option Enable View Layout.
Please review the chapter Customizing
the Reaction Window for a detailed description.
The phase parameters show all settings concerning the reaction phases.
These settings will initially be defined in Step 4 of the Reaction Wizard and can be
edited here. Please refer to Reaction Wizard chapter or the section Add/Remove
Phases for a detailed description of the parameters. Additional phases
may be added or removed by using the Add
Phase and Remove Phase
buttons from the Control
Panel. The buttons are only available if the phase parameter tab is
active.
The general parameters contain settings that concern the instrument,
general naming and the saving options similar to Step 3 of the Reaction Wizard. Please refer
to that chapter for a detailed description of the parameters.
Limits that have been added to the reaction will be shown in this parameter
section. The limit settings may be edited and new limits can be added
or removed using Add Limit
and Remove Limit
button. These buttons are only available if the limit parameter tab is
active. Please refer to section Add/Remove Limits for detailed description
of limits.
The preprocessing parameters show all settings relevant to preprocessing
operations that have been added to the reaction. Preprocessing operations
may be edited, added or removed using Edit
, Add and Remove
Preprocessing buttons. These buttons are only available if the limit
parameter tab is active. Please refer to section Add/Remove PreProcessing for detailed description
of preprocessing operations.
buttons from the 
and 
button. These buttons are only available if the limit parameter tab is
active. Please refer to section 
, 
and 
buttons. These buttons are only available if the limit
parameter tab is active. Please refer to section 
